Gunter

In sailing, a gunter is used for two main configurations of rig:

Voile houari, gunter lug, gunter sail, sliding sail

1. The gunter is defined as a wire that leads from one point near the end of a gaff to a point near the other end. A block travels along this wire, and a halyard is attached to this block. This allows the gaff to be raised to the vertical by a single halyard, though another halyard is required at the gaff jaws to control height.
2. The gunter is created by hoops or parrel beads which secure the gaff loosely to the mast in a vertical position. A halyard is bent to the gaff jaws to control height.

A sail raised by either of these means is called a gunter rigged sail. A vessel with a gunter rigged mainsail is called a gunter rig.

Gunter rig is normally used on small gaff rigged sailing vessels, such as sailing canoes (not the International Canoe) and dinghies where the gaff is carried very nearly vertical, forming an extension to the mast so that the sail is triangular, resembling a Bermuda rig. The effect is to have a topmast (the gaff) which is a pseudo telescopic extension of the shorter mast. One reason given for the popularity of the gunter rig in dinghies, notably the Mirror dinghy, is that the mast and yard are sufficiently short to pack neatly inside the hull when a boat is being trailed behind a car.

## Contents

* 1 Operation
* 1.1 Single halyard
* 1.2 Double halyard
* 2 Reefing
* 3 Confusion between Gaff Rig and Gunter Rig
* 4 See also
* 5 External links

## Operation

In what follows, broadly speaking, the 'single halyard' sail is known as a "sliding gunter," while the 'double halyard' sail is a "folding gunter." The sliding gunter yard stays essentially vertical while being raised, while the folding gunter is 'hinged' up to the mast from the horizontal, much like a high-peaked gaff sail.

It should also be noted that while the term yard is normally employed to name a spar which crosses a mast, and gaff one which is fastened to the mast at its forward point — as it is in the case of the gunter rig. However, since the gunter rig is derived from lug rigs \- where the spar from which the sail hangs is always called the yard, rather than from gaff rig - despite the similarity between a high peaked gaff rig and a gunter rig, the spar will often be referred to either as a gaff or a yard.

Sliding gunter sail rig on Drascombe Lugger Onkahye

### Single halyard

1. fix the gaff loosely to the mast in a vertical position, parallel to it, with either hoops or parrel beads so that it will slide freely to the desired height, and ensure that the sail is bent to the gaff.
2. secure jaws of the gaff around the mast with parrel beads if the gaff is a jawed gaff, or rely on the hoop if hoops are employed.
3. bend the throat halyard to the jaws
4. haul the jaws up the mast until the desired height is reached and make fast
5. using whatever reefing mechanism you have, usually reefing points, reef any excess sail at the foot to the boom (if any) or gather the belly of the sail if loose footed.

Even with a single halyard the hooped gunter is a vertical sliding gaff

### Double halyard

One halyard, the peak halyard, has a block, sometimes just a shackle, that allows the gunter (wire parallel to the gaff and fixed to it at two points on its upper (or leading) surface) to raise the gaff into the vertical position up against and parallel to the mast. The other, the throat halyard, is used to raise or lower the jaws of the gaff.

The mode of operation is:

1. bend the peak halyard to the sliding device on the gunter
2. bend the throat halyard to the jaws
3. secure the parrel beads around the mast from jaw to jaw to locate the jaws positively around the mast
4. haul the gaff into the vertical with the peak halyard and make fast
5. haul the jaws up the mast with the throat halyard until the desired height is reached and make fast
6. using whatever reefing mechanism you have, usually reefing points on larger vessels, reef any excess sail at the foot to the boom (if any) or gather the belly of the sail if loose footed.
7. adjust the tension in the luff of the sail by adjusting the throat halyard, downhaul, gooseneck or any combination of these.

## Reefing

Gunter rigged boat with two reefing lines reeved through the sail

Reefing a gunter rigged boat with a single halyard requires the sail to be fully lowered into the boat and (usually) the halyard repositioned on the yard or (rarely) the sail to be moved downwards along the yard. However some gunter rigged boats, certainly amongst dinghies, have an additional halyard from the end of the yard, to hoist the sail once the yard is hoisted; these are still technically gunter rigged but have borrowed some of the characteristics of the Bermudian rig; essentially the yard is hosted fully and then left in position and regarded as a semi-permanent topmast, with the sail raised up or down it as required.

## Confusion between Gaff Rig and Gunter Rig

Over time the two terms have been used with some interchangeability. While a true gaff rig is with the gaff at an angle to the mast, small boats such as the Heron, the Mirror dinghy, both designed by Jack Holt, and other small sailing dinghies have small, light gaffs which are raised to the vertical position by a single halyard fixed close to the midpoint of the gaff.

This looks like a gunter rig when the boat is fully rigged. However it does not have the sliding component of the wire or the hooped gunter.

Nonetheless such small dinghies have been termed 'gunter rigged' and 'gaff rigged' with free use of each term. It is likely that the fluidity of language allows both terms to be used with correctness for these small boats. For larger craft the terms tend to be more rigorously applied.

## See also

* Gaff rig
* Crab claw sail
* Sail plan

## External links

* Description of rigs, with pictures
* Drascombe Lugger sliding gunter rig

* v
* t
* e

Types of sailing vessels and rigs

Overviews|

* Age of Sail
* Maritime history
* Age of Discovery

Sailing rigs|

* Bermuda rig
* Crab claw
* Fore-and-aft rig
* Gaff rig
* Gunter rig
* Junk rig
* Lateenrig
* Ljungström rig
* Lug rig
* Pinisi rig
* Square rig
* Tanja rig

By sailing rigs|

* Barque
* Barquentine
* Brig
* Brigantine
* Catboat
* Cutter
* Full-rigged ship
* Jackass-barque
* Ketch
* Lugger
* Mistico
* Schooner
* Sloop
* Yawl

Multihull vessels|

* ʻalia
* Amatasi
* Baurua
* Bigiw
* Camakau
* Catamaran
* Drua
* Guilalo
* Jukung
* Kalia
* Karakoa
* Kora kora
* Lakatoi
* Lanong
* Outrigger canoe
* Pahi
* Paraw
* Pentamaran
* Proa
* Quadrimaran
* Takia
* Tongiaki
* Trimaran
* Ungalawa
* Vinta

Naval and merchant
sailing ships
and other vessels
(by origin date)|

| Ancient|

* Balangay
* Boita
* Borobudur ship
* Dhow
* Fire ship
* Galley
* Penteconter
* Bireme
* Trireme
* Quadriremes
* Tessarakonteres
* Dromon
* Junk
* K'un-lun po
* Lepa
* Mtepe
* Uru

|

Post-classical|

* Balinger
* Benawa
* Birlinn
* Bomb vessel
* Cog
* Hulk
* Jong
* Knarr
* Koch
* Kondura
* Longship
* Malangbang
* Shitik
* Tongkang
* Zabra

15th c.|

* Carrack
* Chinese treasure ship
* Caravel
* Ghurab
* Lancaran
* Hoy
* Trabaccolo

16th c.|

* Crommesteven
* Galiot
* Galleon
* Galleass
* Ghali
* Flyboat
* Fluyt
* Full-rigged pinnace
* Lorcha
* Man-of-war
* Manchua
* Panokseon
* Patache
* Speronara
* Square-rigged caravel (round or de armada)
* Xebec

17th c.|

* Bermuda sloop
* Corvette
* Frigate
* Galeas
* Koff
* Pink
* Polacca
* Ship of the line

18th c.|

* Bilander
* Chialoup
* Chinaman
* Baltimore Clipper
* East Indiaman
* Gallivat
* Garay
* Grab
* Gundalow
* Lanong
* Padewakang
* Post ship
* 74-gun
* Ship of the line
* Sloop-of-war
* Toop
* Trincadour
* Slave ship
* West Indiaman

19th c.|

* Blackwall frigate
* Clipper
* Down Easter
* Golekan
* Iron-hulled sailing ship
* Warship
* Janggolan
* Lambo
* Leti leti
* Palari
* Tamar
* West Country
* Windjammer

20th c.|

* Montagu whaler

Fishing vessels|

* Bago
* Falkuša
* Felucca
* Herring buss
* Jangada
* Jukung
* Masula
* Mayang
* Patorani
* Nordland
* Sixareen
* Sgoth
* Smack
* Tartane
* Well smack
* Yoal

Recreational vessels|

* Dinghy
* Pocket cruiser
* Sailing hydrofoil
* Sailing yacht
* Sportsboat
* Trailer sailer
* Wharrams
* Windsurfer
* Yacht

Special terms|

* Inflatable
* Lashed lug
* Razee
* Sewn
* Tall ship
*   * ULDB

Other types|

* Bristol Channel pilot cutter
* Fusta
* Mersey flat
* Norfolk punt
* Norfolk wherry
* Pausik
* Pinnace (ship's boat)
* Pram
* Scow
* Sneakbox
* Thames sailing barge
* Wherry

Related|

* Nautical operations

0.00

(0 votes)

|

Retrieved from "https://handwiki.org/wiki/index.php?title=Engineering:Gunter&oldid=203442"
*[v]: View this template
*[t]: Discuss this template
*[e]: Edit this template