Tuned radio frequency receiver

Short description: Radio receiver with amplifier stages and a detector

This 1920s TRF radio manufactured by Signal is constructed on a breadboard Tuning a TRF receiver, like this 5 tube Neutrodyne set from 1924 with two stages of RF amplification, was a complicated process. The three tuned circuits, controlled by the 3 large knobs, had to be tuned in unison to the new station. So tuning in a station was a process of successive approximation. Once a station was found, the numbers on the dials were written down, so it could be found again. Tuning all 3 stages of a TRF set in unison. This 1925 Grebe Synchrophase receiver has thumbwheels instead of knobs which can be turned with a finger, so a third hand is not needed.

A tuned radio frequency receiver (or TRF receiver) is a type of radio receiver that is composed of one or more tuned radio frequency (RF) amplifier stages followed by a detector (demodulator) circuit to extract the audio signal and usually an audio frequency amplifier. This type of receiver was popular in the 1920s. Early examples could be tedious to operate because when tuning in a station each stage had to be individually adjusted to the station's frequency, but later models had ganged tuning, the tuning mechanisms of all stages being linked together, and operated by just one control knob. By the mid 1930s, it was replaced by the superheterodyne receiver patented by Edwin Armstrong.

## Contents

* 1 Background
* 2 Advantages and disadvantages
* 3 Modern usage
* 4 See also
* 5 Footnotes
* 6 References
* 7 Further reading
* 8 External links

## Background

The TRF receiver was patented in 1916 by Ernst Alexanderson.[1] His concept was that each stage would amplify the desired signal while reducing the interfering ones. Multiple stages of RF amplification would make the radio more sensitive to weak stations, and the multiple tuned circuits would give it a narrower bandwidth and more selectivity than the single stage receivers common at that time. All tuned stages of the radio must track and tune to the desired reception frequency. This is in contrast to the modern superheterodyne receiver that must only tune the receiver's RF front end and local oscillator to the desired frequencies; all the following stages work at a fixed frequency and do not depend on the desired reception frequency.

Antique TRF receivers can often be identified by their cabinets. They typically have a long, low appearance, with a flip-up lid for access to the vacuum tubes and tuned circuits. On their front panels there are typically two or three large dials, each controlling the tuning for one stage. Inside, along with several vacuum tubes, there will be a series of large coils. These will usually be with their axes at right angles to each other to reduce magnetic coupling between them.

TRF receivers were widely manufactured in the 1920s by companies such as Crosley Radio Corporation.

A problem with the TRF receiver built with triode vacuum tubes is the triode's interelectrode capacitance. The interelectrode capacitance allows energy in the output circuit to feedback into the input. That feedback can cause instability and oscillation that frustrate reception and produce squealing or howling noises in the speaker. In 1922, Louis Alan Hazeltine invented the technique of neutralization that uses additional circuitry to partially cancel the effect of the interelectrode capacitance.Cite error: Closing `</ref>` missing for `<ref>` tag

The detector was usually a grid-leak detector. Some sets used a crystal detector (semiconductor diode) instead. Occasionally, a regenerative detector was used, to increase selectivity.

Some TRF sets that were listened to with earphones didn't need an audio amplifier, but most sets had one to three transformer-coupled or RC-coupled audio amplifier stages to provide enough power to drive a loudspeaker.

The schematic diagram shows a typical TRF receiver. This particular example uses six triodes. It has two radio frequency amplifier stages, one grid-leak detector/amplifier and three class ‘A’ audio amplifier stages. There are 3 tuned circuits T1-C1, T2-C2, and T3-C3. The second and third tuning capacitors, C2 and C3, are ganged together (indicated by line linking them) and controlled by a single knob, to simplify tuning. Generally, two or three RF amplifiers were required to filter and amplify the received signal enough for good reception.

## Advantages and disadvantages

Terman characterizes the TRF's disadvantages as "poor selectivity and low sensitivity in proportion to the number of tubes employed. They are accordingly practically obsolete."[2] Selectivity requires narrow bandwidth, but the bandwidth of a filter with a given Q factor increases with frequency. So to achieve a narrow bandwidth at a high radio frequency required high-Q filters or many filter sections. Achieving constant sensitivity and bandwidth across an entire broadcast band was rarely achieved. In contrast, a superheterodyne receiver translates the incoming high radio frequency to a lower intermediate frequency which does not change. The problem of achieving constant sensitivity and bandwidth over a range of frequencies arises only in one circuit (the first stage) and is therefore considerably simplified.

The major problem with the TRF receiver, particularly as a consumer product, was its complicated tuning. All the tuned circuits need to track to keep the narrow bandwidth tuning. Keeping multiple tuned circuits aligned while tuning over a wide frequency range is difficult. In the early TRF sets the operator had to perform that task, as described above. A superheterodyne receiver only needs to track the RF and LO stages; the onerous selectivity requirements are confined to the IF amplifier which is fixed-tuned.

During the 1920s, an advantage of the TRF receiver over the regenerative receiver was that, when properly adjusted, it did not radiate interference.[3][4] The popular regenerative receiver, in particular, used a tube with positive feedback operated very close to its oscillation point, so it often acted as a transmitter, emitting a signal at a frequency near the frequency of the station it was tuned to.[3][4] This produced audible heterodynes, shrieks and howls, in other nearby receivers tuned to the same frequency, bringing criticism from neighbors.[3][4] In an urban setting, when several regenerative sets in the same block or apartment house were tuned to a popular station, it could be virtually impossible to hear.[3][4] Britain,[5] and eventually the US, passed regulations that prohibited receivers from radiating spurious signals, which favored the TRF.

## Modern usage

Although the TRF design has been largely superseded by the superheterodyne receiver, with the advent of semiconductor electronics in the 1960s the design was "resurrected" and used in some simple integrated radio receivers for hobbyist radio projects, kits, and low-end consumer products. One example is the ZN414 TRF radio integrated circuit from Ferranti in 1972 shown below

## See also

* Crystal radio
* Low IF receiver
* Regenerative circuit
* Superheterodyne receiver
* Tuner (radio)

## Footnotes

## References

1. ↑ , Ernst F. W."Selective tuning system"  patent US1173079A, issued 1916-02-22
2. ↑ Terman 1943, p. 658 harvnb error: no target: CITEREFTerman1943 (help)
3. ↑ 3.0 3.1 3.2 3.3 Glasgow, R. S. (June 1924). "Radiating Receivers". Radio in the Home (Philadelphia, PA: Henry M. Neely Publishing Co.) 3 (1): 16, 28. https://www.worldradiohistory.com/Archive-Radio-in-the-Home/20s/RitH-1924-Jun.pdf. Retrieved March 14, 2014. "But the interference due to regenerative receivers when in the oscillating condition cannot be eliminated by anything the receiving operator can do. ... All types of regenerative sets will cause the connected aerial to radiate energy if allowed to oscillate.".
4. ↑ 4.0 4.1 4.2 4.3 Ringel, Abraham (November 1922). "The Receiver Radiation Problem and Some Solutions". The Radio Age 10 (2): 67–69. https://books.google.com/books?id=vd7mAAAAMAAJ&pg=RA1-PA67. Retrieved August 22, 2014.
5. ↑ "How the Motor Patrol Wars with Bloopers". Radio News (New York: Experimenter Publishing Co.) 9 (1): 37. July 1927. https://www.worldradiohistory.com/Archive-Radio-News/20s/Radio-News-1927-07-R.pdf. Retrieved August 23, 2014.

## Further reading

* Tomasi, Wayne (2004), Electronic Communications Systems: Fundamentals Through Advanced (5th ed.), Pearson Education, ISBN 9780130494924, https://archive.org/details/electroniccommun0005toma

## External links

* v
* t
* e

Telecommunications

History|

* Beacon
* Broadcasting
* Cable protection system
* Cable TV
* Communications satellite
* Computer network
* Data compression
* audio
* DCT
* image
* video
* Digital media
* Internet video
* online video platform
* social media
* streaming
* Drums
* Edholm's law
* Electrical telegraph
* Fax
* Heliographs
* Hydraulic telegraph
* Information Age
* Information revolution
* Internet
* Mass media
* Mobile phone
* Smartphone
* Optical telecommunication
* Optical telegraphy
* Pager
* Photophone
* Prepaid mobile phone
* Radio
* Radiotelephone
* Satellite communications
* Semaphore
* Semiconductor
* device
* MOSFET
* transistor
* Smoke signals
* Telecommunications history
* Telautograph
* Telegraphy
* Teleprinter (teletype)
* Telephone
* The Telephone Cases
* Television
* digital
* streaming
* Undersea telegraph line
* Videotelephony
* Whistled language
* Wireless revolution

Pioneers|

* Nasir Ahmed
* Edwin Howard Armstrong
* Mohamed M. Atalla
* John Logie Baird
* Paul Baran
* John Bardeen
* Alexander Graham Bell
* Tim Berners-Lee
* Jagadish Chandra Bose
* Walter Houser Brattain
* Vint Cerf
* Claude Chappe
* Yogen Dalal
* Donald Davies
* Lee de Forest
* Philo Farnsworth
* Reginald Fessenden
* Elisha Gray
* Oliver Heaviside
* Erna Schneider Hoover
* Harold Hopkins
* Internet pioneers
* Bob Kahn
* Dawon Kahng
* Charles K. Kao
* Narinder Singh Kapany
* Hedy Lamarr
* Innocenzo Manzetti
* Guglielmo Marconi
* Robert Metcalfe
* Antonio Meucci
* Jun-ichi Nishizawa
* Radia Perlman
* Alexander Stepanovich Popov
* Johann Philipp Reis
* Claude Shannon
* Henry Sutton
* Nikola Tesla
* Camille Tissot
* Alfred Vail
* Charles Wheatstone
* Vladimir K. Zworykin

Transmission
media|

* Coaxial cable
* Fiber-optic communication
* optical fiber
* Free-space optical communication
* Molecular communication
* Radio waves
* wireless
* Transmission line
* data transmission circuit
* telecommunication circuit

Network topology
and switching|

* Bandwidth
* Links
* Nodes
* terminal
* Network switching (circuit
* packet)
* Telephone exchange

Multiplexing|

* Space-division
* Frequency-division
* Time-division
* Polarization-division
* Orbital angular-momentum
* Code-division

Networks|

* ARPANET
* BITNET
* Cellular network
* Computer
* CYCLADES
* Ethernet
* FidoNet
* Internet
* Internet2
* ISDN
* LAN
* Mobile
* NGN
* NPL network
* Public Switched Telephone
* Radio
* Telecommunications equipment
* Television
* Telex
* WAN
* Wireless network
* World Wide Web

* Category
* Outline
* Portal
* Commons

0.00

(0 votes)

Original source: https://en.wikipedia.org/wiki/Tuned radio frequency receiver. Read more

|

Retrieved from "https://handwiki.org/wiki/index.php?title=Engineering:Tuned_radio_frequency_receiver&oldid=4379306"
*[v]: View this template
*[t]: Discuss this template
*[e]: Edit this template