Stopband

Frequency response of an example bandpass filter. The frequencies between a stopband and a passband define the transition band.

A stopband is a band of frequencies, between specified limits, through which a circuit, such as a filter or telephone circuit, does not allow signals to pass, or the attenuation is above the required stopband attenuation level.[1] Depending on application, the required attenuation within the stopband may typically be a value between 20 and 120 dB higher than the nominal passband attenuation, which often is 0 dB.

The lower and upper limiting frequencies, also denoted lower and upper stopband corner frequencies, are the frequencies where the stopband and the transition bands meet in a filter specification. The stopband of a low-pass filter is the frequencies from the stopband corner frequency (which is slightly higher than the passband 3 dB cut-off frequency) up to the infinite frequency. The stopband of a high-pass filter consists of the frequencies from 0 hertz to a stopband corner frequency (slightly lower than the passband cut-off frequency).

A band-stop filter has one stopband, specified by two non-zero and non-infinite corner frequencies. The difference between the limits in the band-stop filter is the stopband bandwidth, which usually is expressed in hertz.

A bandpass filter typically has two stopbands. The shape factor of a bandpass filter is the relationship between the 3 dB bandwidth, and the difference between the stopband limits.

## See also

* Passband
* Band-stop filter
* Band gap in solid state physics
* Band rejection

## References

1. ↑ "Stopband,version of FS-1037C was last generated on Fri Aug 23 00:22:38 MDT 1996". https://www.its.bldrdoc.gov/fs-1037/dir-035/_5133.htm.

sv:Stoppband

0.00

(0 votes)

Original source: https://en.wikipedia.org/wiki/Stopband. Read more

|

Retrieved from "https://handwiki.org/wiki/index.php?title=Stopband&oldid=225810"