Explorer 48

From HandWiki - Reading time: 5 min

Short description: NASA satellite of the Explorer program
Explorer 48
SAS 2.gif
Explorer 48 satellite
NamesSAS-B
SAS-2
Small Astronomy Satellite-2
Mission typeX-ray astronomy
OperatorNASA
COSPAR ID1972-091A
SATCAT no.06282
Spacecraft properties
SpacecraftExplorer XLVIII
Spacecraft typeSmall Astronomy Satellite
BusSAS
ManufacturerGoddard Space Flight Center
Launch mass166 kg (366 lb)
Dimensions59 cm (23 in) in diameter and 135 cm (53 in) in length
PowerSolar paddles with a 12-cell nickel–cadmium battery
Start of mission
Launch date15 November 1972, 22:13:46 UTC
RocketScout D-1 (S-170CR)
Launch siteBroglio Space Center,
San Marco platform
ContractorVought
Entered service15 November 1972
End of mission
Last contact8 June 1973
Decay date20 August 1980
Orbital parameters
Reference systemGeocentric orbit[1]
RegimeLow Earth orbit
Perigee altitude443 km (275 mi)
Apogee altitude632 km (393 mi)
Inclination1.90°
Period95.40 minutes
Instruments
Gamma-Ray Telescope
Explorer program
 

Explorer 48 was a satellite launched specifically for the purpose of X-ray astronomy of the NASA. It was also known as the SAS-B (for Small Astronomy Satellite-B, being second of the three-spacecraft SAS series), SAS-2.[2]

Mission

Explorer 48 was designed to extend the astronomical studies in the X-ray, gamma-ray, ultraviolet, visible, and infrared regions. The primary objective of the SAS-B was to measure the spatial and energy distribution of primary galactic and extragalactic gamma radiation with energies between 20 and 300 MeV. The instrumentation consisted principally of a guard scintillation detector, an upper and a lower spark chamber, and a charged particle telescope.[2]

Launch

The spacecraft was launched on 15 November 1972 into an initial orbit of about 632 km (393 mi) of apogee, 443 km (275 mi) of perigee, 1.90° of orbital inclination, with an orbital period of 95.40 minutes.[1] from the San Marco platform off the coast of Kenya, Africa, into a nearly equatorial orbit. The orbiting spacecraft was in the shape of a cylinder approximately 59 cm (23 in) in diameter and 135 cm (53 in) in length. Four solar paddles were used to recharge a 6 amp-h, eight-cell, nickel–cadmium battery and provide power to the spacecraft and telescope experiment. The spacecraft was spin stabilized by an internal wheel, and a magnetically torqued commandable control system was used to point the spin axis of the spacecraft to any point of the sky within approximately 1°. The experiment axis lay along this axis allowing the telescope to look at any selected region of the sky with its ± 30° acceptance aperture. The nominal spin rate was 1/12 rpm. Data were taken at 1000 bps and could be recorded on an onboard tape recorder and simultaneously transmitted in real time. The recorded data were transmitted once per orbit. This required approximately 5 minutes.[2]

Experiment

The telescope experiment was initially turned on 20 November 1972 and by 27 November 1972, the spacecraft became fully operational. The low-voltage power supply for the experiment failed on 8 June 1973. No useful scientific data were obtained after that date. With the exception of a slightly degraded star sensor, the spacecraft control section performed in an excellent manner.[2]

Gamma-Ray Telescope

The instrument consisted of two spark-chamber assemblies, four plastic scintillation counters, four Cherenkov counters, and an anticoincidence scintillation counter dome assembled to form a telescope. The spark chamber assembly consisted of 16-wire spark-chamber modules with a magnetic core readout system. Sandwiched between these two assemblies was a plane of plastic scintillator formed by the four scintillation counters. Thin tungsten plates, averaging 0.010 cm (0.0039 in) thick, were interleaved between the spark chamber modules, which had an active area of 640-cm2. These plates provided the material for the gamma ray to convert into an electron-positron pair and provided a means of determining the energy of these particles by measuring their coulomb scattering. The spark chamber modules revealed the position and direction of the particles; from this information, the energy and direction of the gamma ray was determined. The scintillation counters and the four directional Cerenkov counters that were placed below the second spark chamber assembly constituted four independent counter coincidence systems. The single-piece plastic scintillator dome surrounded the whole assembly except at the bottom to discriminate against charged particles. The threshold of the instrument was about 30-MeV, and energies up to about 200-MeV could be measured along with the integral flux above 200 MeV. The angular resolution of the telescope varied as a function of energy and arrival direction from 1.5° to 5°. During the lifetime of the experiment from 15 November 1972 to 8 June 1973, approximately 55% of the celestial sphere, including most of the galactic plane, was surveyed.[3]

See also

  • Explorer program
  • Explorer 42

References

  1. 1.0 1.1 "Trajectory: Explorer 48 (SAS-B) 1972-091A". NASA. 28 October 2021. https://nssdc.gsfc.nasa.gov/nmc/spacecraft/displayTrajectory.action?id=1972-091A.  This article incorporates text from this source, which is in the public domain.
  2. 2.0 2.1 2.2 2.3 "Display: Explorer 48 (SAS-B) 1972-091A". NASA. 28 October 2021. https://nssdc.gsfc.nasa.gov/nmc/spacecraft/display.action?id=1972-091A.  This article incorporates text from this source, which is in the public domain.
  3. "Experiment: Gamma-Ray Telescope". NASA. 28 October 2021. https://nssdc.gsfc.nasa.gov/nmc/experiment/display.action?id=1972-091A-01.  This article incorporates text from this source, which is in the public domain.





Licensed under CC BY-SA 3.0 | Source: https://handwiki.org/wiki/Astronomy:Explorer_48
6 views | Status: cached on August 25 2024 06:02:29
↧ Download this article as ZWI file
Encyclosphere.org EncycloReader is supported by the EncyclosphereKSF