Mini-Fly Set
Topic: Engineering
From HandWiki - Reading time: 2 min
| Mini-Fly Set | |
|---|---|
| Role | Powered hang glider |
| National origin | Germany |
| Manufacturer | Mini-Fly GmbH |
| Status | Production completed |
The Mini-Fly Set is a German powered hang glider that was designed and produced by Mini-Fly GmbH of Kirchardt. Now out of production, when it was available the aircraft was supplied complete and ready-to-fly.[1]
Design and development
The aircraft features a cable-braced hang glider-style high-wing, weight-shift controls, single-place accommodation, foot-launching and landing and a single engine in pusher configuration.[1]
The aircraft uses a standard hang glider wing, made from bolted-together aluminum tubing, with its double surface wing covered in Dacron sailcloth. The wing is supported by a single tube-type kingpost and uses an "A" frame control bar. The engine is a two-stroke, single cylinder Sachs 166 industrial engine of 14 hp (10 kW) driving a 3.4:1 reduction drive. The engine is mounted at the front of, and below the wing on a separate tube running parallel to the wing's keel tube. The 10 litres (2.2 imp gal; 2.6 US gal) fuel tank is mounted above and behind the engine. The two-bladed, wooden, fixed pitch propeller with a 134 cm (53 in) diameter is located at the rear of the wing's keel tube and is protected from ground contact by a tail wheel mounted on a long aluminum tube. The propeller is driven by a long extension shaft.[1]
The pilot may take off in the prone position or from a standing start as in a conventional hang glider hill launch.[1]
Specifications
Data from Bertrand[1]
General characteristics
- Crew: one
- Empty weight: 16 kg (35 lb) power unit only
- Fuel capacity: 10 litres (2.2 imp gal; 2.6 US gal)
- Powerplant: 1 × Sachs 166 single cylinder, air-cooled industrial engine with a 3.4:1 reduction drive, 10 kW (14 hp)
- Propellers: 2-bladed wooden, fixed pitch, 1.34 m (4 ft 5 in) diameter
References
 |  |
EncycloReader
is supported by the 
KSF