Table of Contents Categories
  Encyclosphere.org ENCYCLOREADER
  supported by EncyclosphereKSF

Application of silicon-germanium thermoelectrics in space exploration

Topic: Physics

 From HandWiki - Reading time: 5 min
Essential components of a SiGe radioisotope thermoelectric generator

Silicon-germanium (SiGe) thermoelectrics have been used for converting heat into electrical power in spacecraft designed for deep-space NASA missions since 1976. This material is used in the radioisotope thermoelectric generators (RTGs) that power Voyager 1, Voyager 2, Galileo, Ulysses, Cassini, and New Horizons spacecraft. SiGe thermoelectric material converts enough radiated heat into electrical power to fully meet the power demands of each spacecraft. The properties of the material and the remaining components of the RTG contribute towards the efficiency of this thermoelectric conversion.

Properties

Components of the SiGe unicouple

Heavily doped semiconductors, such as silicon-germanium (SiGe) thermoelectric couples (also called thermocouples or unicouples), are used in space exploration.[1][2]

SiGe alloys present good thermoelectric properties. Their performance in thermoelectric power production is characterized by high dimensionless figures-of-merit (ZT) under high temperatures, which has been shown to be near 2 in some nanostructured-SiGe models.[3][4][5]

SiGe alloy devices are mechanically rugged and can withstand severe shock and vibration due to its high tensile strength (i.e. >7000 psi) and low dislocation density.[3][6] SiGe material is malleable with standard metallurgical equipment and bonds easily to construct components.[3] SiGe alloy devices can operate under high temperatures (i.e. >1300 ˚C) without degradation due to their electronic stability, low thermal expansion coefficient and high oxidation resistance.[3][6][7]

Near the Sun, solar cell performance deteriorates from high incident particle flux and high temperatures from heat flux.[8] However, thermoelectric energy conversion systems that use thermoelectric materials (e.g. SiGe alloys) as a supplemental source of power for missions near the Sun can operate unprotected in vacuum and air environments under high temperatures due to their low sensitivity to radiation damage.[8] Such properties have made SiGe thermoelectrics convenient for power generation in space. The multifoil cold stack assembly, composed of molybdenum, tungsten, stainless steel, copper, and alumina materials, provides the insulation between the electrical and thermal currents of the system. The SiGe n-leg doped with boron and SiGe p-leg doped with phosphorus act as the intermediary between the heat source and electrical assembly.

Power generation

SiGe thermocouples in an RTG convert heat directly into electricity. Thermoelectric power generation requires a constantly maintained temperature difference among the junctions of the two dissimilar metals (i.e. Si and Ge) to produce a low power closed circuit electric current without extra circuitry or external power sources.[3][9]

A large array of SiGe thermocouples/unicouples form a thermopile that was incorporated into the design of radioisotope thermoelectric generators (RTGs) used in the missions Voyager, Galileo, Ulysses, Cassini, and New Horizons.[10] On these spacecraft, Pu-238 dioxide fuel undergoes natural decay. The SiGe thermocouples/unicouples convert this heat to hundreds of Watts of electrical power.[9]

Thermocouple/unicouple assembly

Conceptual diagram of a thermocouple (unicouple)

The thermocouples/unicouples attached to the outer shell consist of a SiGe alloy n-leg doped with boron and a SiGe p-leg doped with phosphorus to provide thermoelectric polarity to the couple.[6][11] The electrical and thermal currents of the system are separated by bonding the SiGe alloy thermocouple to a multifoil cold stack assembly of molybdenum, tungsten, stainless steel, copper, and alumina components.[11] Several layers of Astroquartz silica fiber yarn electrically insulate the legs of the SiGe thermocouples. In between the inner insulation system and the outer shell, copper connectors form the electrical circuit, which uses a two-string, series-parallel wiring design to connect the unicouples.[citation needed] The circuit loop arrangement minimizes the net magnetic field of the generator.[11]

Application history

RTG Space Exploration Timeline

SiGe has been used as a material in RTGs since 1976. Each mission that has used RTG technology involves exploration of far-reaching regions of the solar system. The most recent mission, New Horizons (2005), was originally set for a 3-year exploration, but was extended to 17 years.

Multi-hundred-watt (MHW) applications

Voyager 1 and Voyager 2 spacecraft launched in August and September 1977 required multi-hundred-watt (MHW) RTG containing plutonium oxide fuel spheres for an operational life appropriate for exploration of Jupiter, Saturn, Uranus, and Neptune.[9] Conversion of the decay heat of the plutonium to electrical power was accomplished through 312 silicon-germanium (SiGe) thermoelectric couples. A hot junction temperature of 1273 K (1832 °F) with a cold junction temperature of 573 K (572 °F) compose the temperature gradient in the thermoelectric couple in the RTG.[9] This mechanism provided the total electrical power to operate the spacecraft's instruments, communications and other power demands. The RTG on Voyager will produce adequate electrical power for spacecraft operation until about the year 2020.[9] Similar MHW-RTG models are also used on the two U.S. Air Force communications Lincoln Experimental Satellites 8 and 9 (LES-8/9).[10]

General purpose heat source (GPHS) applications

The Galileo spacecraft launched on October 18, 1989, the Ulysses on October 6, 1990, the Cassini on October 15, 1997, and the New Horizons on January 19, 2006. All of these spacecraft contain the general purpose heat source (GPHS) RTG commissioned by the U.S. Department of Energy.[citation needed] The GPHS-RTG employs identical heat-to-electrical conversion technology used in the MHW-RTGs from the Voyager missions, using SiGe thermocouples/unicouples and the Pu-238–fueled GPHS.[9] New Horizons made its historic flyby past Pluto and its moons on July 14, 2015 (see JHU Applied Physics website). The spacecraft's next destination will be a small Kuiper Belt object (KBO) known as 486958 Arrokoth that orbits nearly a billion miles beyond Pluto.[12] Based on performance, data and modeling for the SiGe alloy RTGs, the GPHS-RTGs on Ulysses, Cassini and New Horizons are expected to meet or exceed the remaining power performance requirements for their deep-space missions.[3]

RTG alternative

Missions after 2010 requiring RTGs will instead use the multi-mission radioisotope thermoelectric generator (MMRTG) containing lead telluride (PbTe) thermocouples and Pu-238 dioxide for spacecraft power applications.[citation needed]

See also

References

  1. ↑ Tiwari, Pratibha; Gupta, Nishu; Gupta, K.M. (April 2013). "Advanced Thermoelectric Materials in Electrical and Electronic Applications". Advanced Materials Research 685: 161–165. doi:10.4028/www.scientific.net/AMR.685.161. Bibcode: 2012AdMaR.443.1587Z. 
  2. ↑ Böttner, H. (August 2002). "Thermoelectric micro devices: Current state, recent developments and future aspects for technological progress and applications". Twenty-First International Conference on Thermoelectrics, 2002. Proceedings ICT '02. pp. 511–518. doi:10.1109/ICT.2002.1190368. ISBN 978-0-7803-7683-0. 
  3. ↑ 3.0 3.1 3.2 3.3 3.4 3.5 Dingwall, F. (May 1963). "Optimization of Silicon-Germanium Thermoelectric Modules for Transportation Corps Silent Boat Design". Radio Corporation of America TRECOM Technical Report 63-17. Accession Number: AD0412341. http://www.dtic.mil/dtic/tr/fulltext/u2/412341.pdf. 
  4. ↑ Lee, Eun Kyung; Yin, Liang; Lee, Yongjin; Lee, Jong Woon; Lee, Sang Jin; Lee, Junho; Cha, Seung Nam; Whang, Dongmok et al. (13 June 2012). "Large Thermoelectric Figure-of-Merits from SiGe Nanowires by Simultaneously Measuring Electrical and Thermal Transport Properties". Nano Letters 12 (6): 2918–2923. doi:10.1021/nl300587u. PMID 22548377. Bibcode: 2012NanoL..12.2918L. 
  5. ↑ Joshi, Giri; Lee, Hohyun; Lan, Yucheng; Wang, Xiaowei; Zhu, Gaohua; Wang, Dezhi; Gould, Ryan W.; Cuff, Diana C. et al. (10 December 2008). "Enhanced Thermoelectric Figure-of-Merit in Nanostructured p-type Silicon Germanium Bulk Alloys". Nano Letters 8 (12): 4670–4674. doi:10.1021/nl8026795. PMID 19367858. Bibcode: 2008NanoL...8.4670J. 
  6. ↑ 6.0 6.1 6.2 Xie, Ming; Gruen, Dieter M. (18 November 2010). "Potential Impact of ZT = 4 Thermoelectric Materials on Solar Thermal Energy Conversion Technologies". The Journal of Physical Chemistry B 114 (45): 14339–14342. doi:10.1021/jp9117387. PMID 20196558. 
  7. ↑ Jurgensmeyer, Austin Lee (Summer 2011). "High efficiency thermoelectric devices fabricated using quantum well confinement techniques". https://projects-web.engr.colostate.edu/ionstand/graduates/papers/Jurgensmeyer%20Thesis.pdf. 
  8. ↑ 8.0 8.1 Raag, V.; Berlin, R.E. (December 1968). "A silicon-germanium solar thermoelectric generator". Energy Conversion 8 (4): 161–168. doi:10.1016/0013-7480(68)90033-8. 
  9. ↑ 9.0 9.1 9.2 9.3 9.4 9.5 Furlong, Richard R.; Wahlquist, Earl J. (April 1999). "U.S. Space Missions Using Radioisotope Power Systems.". American Nuclear Society. Nuclear News. http://www3.ans.org/pubs/magazines/nn/pdfs/1999-4-2.pdf. 
  10. ↑ 10.0 10.1 Fleurial, Jean-Pierre; Caillat, Thierry; Nesmith, Bill J.; Ewell, Richard C.; Woerner, David F.; Carr, Gregory C.; Jones, Loren E.. "Thermoelectrics: From Space Power Systems to Terrestrial Waste Heat Recovery Applications". http://energy.gov/sites/prod/files/2014/03/f13/fluerial.pdf. 
  11. ↑ 11.0 11.1 11.2 Bennett, G.L; Lombardo, James; Hemler, Richard; Silverman, Gil; Whitmore C.; Amos, Wayne; Johnson, E.; Schock, Alfred; Zocher, Roy; Keenan, Thomas; Hagan, James; and Richard Englehart. Mission of Daring: The General-Purpose Heat Source Radioisotope Thermoelectric Generator, AIAA 2006-4096, 4th International Energy Conversion Engineering Conference and Exhibit (IECEC), 26–29 June 2006, San Diego, California (Accessed 10 February 2015)
  12. ↑ "NASA's New Horizons Team Selects Potential Kuiper Belt Flyby Target". 28 August 2015. https://www.nasa.gov/feature/nasa-s-new-horizons-team-selects-potential-kuiper-belt-flyby-target. 



Retrieved from "https://handwiki.org/wiki/index.php?title=Physics:Application_of_silicon-germanium_thermoelectrics_in_space_exploration&oldid=3278274"
Licensed under CC BY-SA 3.0 | Source: https://handwiki.org/wiki/Physics:Application_of_silicon-germanium_thermoelectrics_in_space_exploration
1 | Status: cached on July 20 2024 02:38:48
↧ Download this article as ZWI file
Encyclosphere.org EncycloReader is supported by the EncyclosphereKSF