SFACT slicer

SFACT is a slicer program for 3D printing. It is a fork of the wellknown skeinforge program that is somewhat easier to use since it relies on some calibration procedure. As a result, there are no flow rate settings, only flow rate modifiers (ratios).

See also:

• Skeinforge for RapMan
• Slicers and user interfaces for 3D printers

Links[edit | edit source]

• SFACT thread in the skeinforge settings (reprap.org)

Software

• http://www.reprapfordummies.net/downloads/SFACT.tar.gz
• GiHub directory (downloads)

Manuals (don't know which is ok, the version installed doesn't fit any)

• Sfact (reprap wiki, probably the best information)
• SFACT the new Skeinforge (July 19, 2011)
• PublicPad version of the FAQ