Daylighting a tunnel is to remove its "roof" of overlying rock and soil, exposing the railway or roadway to daylight and converting it to a railway or roadway cut. Tunnels are often daylighted to improve vertical or horizontal clearances—for example, to accommodate double-stack container trains or electrifying rail lines, where increasing the size of the tunnel bore is impractical.
The Coromandel and Pinera Tunnels on the Belair line in Adelaide, South Australia, both built as a single track tunnel with the line in 1883, were daylighted in the 1920s when the line to Belair was duplicated.[6]
The Arncliffe Tunnel on the NSW South Coast Line was daylighted and replaced with a road bridge when the track was quadruplicated in 1921[7]
The Waterfall Tunnel on the NSW South Coast Line was daylighted in 1914 when the line was duplicated.[8]
New Zealand
The railway line through the Manawatū Gorge, when constructed in 1891, had five tunnels. Three of these(Tunnels No. 3, 4 and 5) were daylighted in 2008 to allow for the carriage of large containers (the other two tunnels had their floors lowered).[9]
The Macgregor Tunnel on the Main South Line was daylighted in 1971 to allow for container freight.[10]
Tunnels No. 22 and 23. were daylighted in 1981 and 1979 respectively on the Main North Line.[10]
The Kiwi Tunnel was daylighted in 1972 on the North Island Main Trunk. This alignment has since been bypassed in 1985 however.[10]
United Kingdom
Liverpool Lime Street station was originally approached through a 1.13-mile (1.82 km) twin-track tunnel completed in 1836. The tunnel was daylighted in the 1880s, and replaced with a deep four-track cutting, with only the eastern 50 metres (55 yd) approaching Edge Hill railway station remaining as a tunnel.
The short remaining portion of Liverpool's Lime Street Station tunnel can be seen west of Edge Hill Station.
^"ROCKHAMPTON". Morning Bulletin. Vol. LXIV, no. 11, 650. Queensland, Australia. 4 April 1903. p. 5. Retrieved 25 April 2024 – via National Library of Australia.