The Pacific Railroad Acts of 1862 were a series of acts of Congress that promoted the construction of a "transcontinental railroad" (the Pacific Railroad) in the United States through authorizing the issuance of government bonds and the grants of land to railroad companies. In 1853, the War Department under then Secretary of War Jefferson Davis was authorized by the Congress to conduct surveys of five different potential transcontinental routes from the Mississippi ranging from north to south. It submitted a massive twelve volume report to Congress with the results in early 1855. However, no route or bill could be agreed upon and passed authorizing the Government's financial support and land grants until the secession of the southern states in 1861 removed their opposition to a central route. The Pacific Railroad Act of 1862 (12 Stat. 489) was the original act. Some of its provisions were subsequently modified, expanded, or repealed by four additional amending Acts: The Pacific Railroad Act of 1863 (12 Stat. 807), Pacific Railroad Act of 1864 (13 Stat. 356), Pacific Railroad Act of 1865 (13 Stat. 504), and Pacific Railroad Act of 1866 (14 Stat. 66).
The Pacific Railroad Act of 1862 began the practice of granting federal government owned lands directly to corporations; before that act, land grants were made to the states, for the benefit of corporations.
Long title | An Act to aid in the construction of a railroad and telegraph line from the Missouri river to the Pacific ocean, and to secure to the government the use of the same for postal, military, and other purposes |
---|---|
Enacted by | the 37th United States Congress |
Citations | |
Statutes at Large | 12 Stat. 489 |
Legislative history | |
| |
Major amendments | |
March 3, 1863; 1864; March 3, 1865 |
The original 1862 Act's long title was An Act to aid in the construction of a railroad and telegraph line from the Missouri river to the Pacific ocean, and to secure to the government the use of the same for postal, military, and other purposes. It was based largely on a proposed bill originally reported six years earlier on August 16, 1856, to the 34th Congress by the Select Committee on the Pacific Railroad and Telegraph.[1] Signed into law by President Abraham Lincoln on July 1, 1862, the 1862 Act authorized extensive land grants[2] in the Western United States and the issuance of 30-year government bonds (at 6 percent) to the Union Pacific Railroad and Central Pacific Railroad (later the Southern Pacific Railroad) companies in order to construct a continuous transcontinental railroad between the eastern side of the Missouri River at Council Bluffs, Iowa (opposite from Omaha, Nebraska)[3][4] and the navigable waters of the Sacramento River in Sacramento, California.[5] Section 2 of the Act granted each Company contiguous rights of way for their rail lines as well as all public lands within 100 feet (30 m) on either side of the track.[6]
Section 3 granted an additional 10 square miles (26 km2) of public land for every mile of grade except where railroads ran through cities or crossed rivers. The method of apportioning these additional land grants was specified in the Act as being in the form of "five alternate sections per mile on each side of said railroad, on the line thereof, and within the limits of ten miles on each side" which thus provided the companies with a total of 6,400 acres (2,600 ha) for each mile of their railroad. (The interspersed non-granted area remained as public lands under the custody and control of the United States General Land Office.) [7] The U.S. Government Pacific Railroad Bonds were authorized by Section 5 to be issued to the companies at the rate of $16,000 per mile of tracked grade completed west of the designated base of the Sierra Nevadas and east of the designated base of the Rocky Mountains (UPRR).[8] Section 11 of the Act provided that the issuance of bonds "shall be treble the number per mile" (to $48,000) for tracked grade completed over and within the two mountain ranges (but limited to a total of 300 miles (480 km) at this rate), and doubled (to $32,000) per mile of completed grade laid between the two mountain ranges[9] Section 12 of the Act provided that the grades and curves were not to exceed the maximum grades and curves of the Baltimore and Ohio Railroad. [10]
The 30-year U.S. government bonds authorized by the act would be issued and backed by the U.S. government, which would then provide the capital raised to the railroad companies upon completion of sections of the railroads in exchange for a lien on that section. The liens covered the railroads and all their fixtures, and all the loans were repaid in full (and with interest) by the companies as and when they became due.
Section 10 of the 1864 amending Act (13 Statutes at Large, 356) additionally authorized the two charter companies to issue their own "First Mortgage Bonds"[11] in total amounts up to (but not exceeding) that of the bonds issued by the United States, and that such company issued securities would have priority over the original Government Bonds.[12]
The amending Act of March 3, 1865 ratified and confirmed the assignment made by Central Pacific Railroad to Western Pacific Railroad to construct the westernmost leg of the Pacific Railroad from Sacramento to San Jose and authorized Western Pacific as one of the charter companies.[13]
From 1850 to 1871, the railroads received more than 175 million acres (71 million ha) of public land – an area more than one tenth of the whole United States and larger in area than Texas.[14]
Railroad expansion provided new avenues of migration into the American interior. The railroads sold portions of their land to arriving settlers at a handsome profit. Lands closest to the tracks drew the highest prices, because farmers and ranchers wanted to locate near railway stations.
The act of March 3, 1863 (12 Sta. 807)[15] was:
This act set the gauge to be used by the railroads at four feet and eight and one-half inches, a gauge that had previously been used by George Stephenson in England for the Liverpool and Manchester Railway (1830) and was already popular with railroads in the Northeastern states. Due in part to the 1863 Act the gauge would come to be widely (but not universally) adopted in the United States and is known as standard gauge. A common gauge choice allowed easy transfer of cars between different railroad companies and facilitates trackage rights between companies.
An act of Congress (May 7, 1878, 20 Stat. 56), which became known as the Thurman Act, was an amendment to solve disputes over the railroad subsidies, revenues, and loan repayments consequential to the original act.[16]